Motion Alarm Handling Configuration; Combination Alarm; Ipc Offline Settings - Speco N8NRN User Manual

General Event Management
system detects a motion, it will go to alarm and would not detect any other motion (specific to camera) in 10 seconds. If there is another motion
detected during this period, it will be considered as continuous movement; otherwise it will be considered as a single motion.
③ Drag the camera image to set the motion area. You can set more than one motion area. Click "All" to set the whole camera image as the
motion area. Click "Reverse" to swap the motion area and the non-motion area. Click "Clear" to clear all the motion areas.
④ Click "Apply" to save the settings. Click "Processing Mode" to go to the alarm handling configuration interface of the motion alarm.

11.2.2 Motion Alarm Handling Configuration

① Click Start Settings Alarm Motion Alarm to go to the following interface.
② Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling setting of
motion alarm is similar to that of the sensor alarm (see 11.1 Sensor Alarm for details).
③ Click "Apply" to save the settings. You can click "Motion Settings" to go to the motion configuration interface.

11.3 Combination Alarm

① Click Start Settings Alarm
② Customize combination alarm. Set alarm name and click "Configure" under the Combined Alarm Configuration item. Then select alarm type
and alarm source. Finally, click "OK" to save the settings.
③ Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm handling setting of
combination alarm is similar to that of the sensor alarm (see 11.1 Sensor Alarm for details).
④ Click "Apply" to save the settings.

11.4 IPC Offline Settings

① Click Start Settings AI/Event IPC Offline Settings to go to the interface as shown below.
② Enable or disable "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video", "Pop-up Message Box" and "E-mail". The IPC Offline
Settings are similar to that of the sensor alarm (see 11.1 Sensor Alarm for details).
③ Click "Apply" to save the settings.
Combination Alarm to go to the following interface.
65
NVR User Manual