Live View Introduction
5.3.3 Mask Settings
Some areas of the image can be masked for privacy. Up to four mask areas can be set for each camera. Click
Start Settings Camera Image Mask Settings to go to the interface as shown below. Select the camera and enable the mask. Click "Draw"
button and then drag the mouse on the image area to set the mask area; click "Delete" button to delete the mask areas; click "Apply" to save the
settings.
5.3.4 Image Adjustment
Go to the live view interface and then click
Image Adjustment
Select the camera and then click "Image Adjustment" to go to image adjustment tab. Refer to the above picture. Drag the slider to set the camera's
brightness, contrast, saturation and hue value. Check sharpen, wide dynamic and denoise and then drag the slider to set the value. Click "Default"
button to set these parameters to default values.
button on the tool bar under the camera window to go to the image adjustment interface.
22
NVR User Manual