Table of Contents
Advertisement
Remote Surveillance
PPPoE Access
① Click Start Settings Network PPPoE to go to the "PPPoE" interface. Check "Enable" in the "PPPoE settings" and then enter the username
and password you get from your ISP. Click "Apply" to save the settings.
② Click Start Settings Network Network Status to view the IP address of the NVR.
③ Open the web browser on your computer, enter the IP address of the NVR like http://210.21.229.138 in the address bar and then press enter
to go to the login interface. Enter the username and password of the NVR in the interface and then click "Login" to go to the live view interface.
Router Access
① Click Start Settings Network TCP/IP to go to the "TCP/IP" interface. Set the IP address, subnet mask, gateway, preferred DNS and
alternate DNS of the NVR.
② Set the HTTP port (it is suggested to modify the HTTP port because the default HTTP port 80 might be taken up) and enable UPnP function in
both the NVR and the router. If the UPnP function is not available in the router, you need to forward the LAN IP address, HTTP port and server port
of the NVR to the router. Port mapping settings may be different in different routers, so please refer to the user manual of the router for details.
③ Get the WAN IP address of the NVR from the router. Open the web browser on your computer, enter the WAN IP address plus HTTP port like
http://116.30.18.215:100 in the address bar and then press enter to go to the login interface. Enter the username and password of the NVR in the
interface and then click "Login" to go to the live view interface.
14.4 Web Remote Control
The supported browsers of the remote surveillance are IE8/9/10/11, Firefox, Opera and Chrome (available only for the versions lower than 45) in
Windows system and Safari in MAC system. Here we take IE browser for example. When you access the NVR through IE for the first time, you need
to download and install the relative components for normal preview and playback. Please refer to the tips in the remote interfaces for details. The
buttons and icons on the top right corner of the remote interface are introduced as follows.
admin: the current login username.
Logout: click it to log out and return to the login interface.
Modify Password: click it to change the password of the current login user. Enter the current password and then set a new password in the popup
window. Click "OK" button to save the new password.
Local Settings: click it to change the local settings. Set the snapshot number and click "Browse" to set the snapshot path and record path as shown
below. Click "Apply" button to save the settings.
14.4.1 Remote Preview
Click "Live View" in the remote interface to go to the live view interface. The live view interface consists of the four areas marked in the following
picture.
Note: If the WAN IP address is a dynamic IP address, it is necessary for you to use the domain name to
access the NVR. Click Start Settings Network DDNS to set DDNS (see 12.1.4 DDNS Configuration
for details). By using DDNS function you can use the domain name plus HTTP port like
http://sunshine.dvrdydns.com:100 to access the NVR via internet.
85
NVR User Manual
Advertisement
Table of Contents
