Pppoe Configuration - Speco N8NRN User Manual

Device Management NVR User Manual
Note: The HTTP port and server port of the NVR should be mapped to the router before you access the NVR via WAN.
API Server: You can log in the media player which supports the RTSP protocol by the username and password here. Moreover, the third-party can
further develop through API service.
Tips: The username and password of API Server here cannot be used to log in NVR. It is recommended to set the password of the API server
different from the password of "admin" that is used to log in NVR.
RTSP Port: RTSP real-time stream protocol can be used to control the sending of real-time data. By media player (like VLC player) which supports
the RTSP real-time stream protocol, you can view the live images synchronously. The default RTSP port is 554 and it can be changed as needed.
(The address format: rtsp://IP address:554/chID=1&streamType=main or rtsp://IP address:554/chID=1&streamType=sub; main indicators main
stream; sub indicators sub stream; chID indicators channel ID).
Examples: ① Enable RTSP and "Anonymous". Then open the VLC player and enter the address (for example:
rtsp://192.168.1.88:554/chID=1&streamType=main) in the network address bar of the VLC player. Then you can view the video of channel 1.
② Enable RTSP and open the VLC player. After that enter the address (for example: rtsp://192.168.1.88:554/chID=1&streamType=sub) in the
network address bar of the VLC player. Then a login box will pop up. Enter the username and password which shall be as the same as the username
and password of API server. Then you can view the video of channel 1.
Note: only some versions may support API server function. Please skip the following instructions if your DVR doesn't support it.
If your NVR is a PoE NVR, you can also enable virtual host in the port setting interface via Web Client. After this function is enabled, the web
settings interface of NVR can be jumped to the web client of the IPC. The setting steps are as follows.
1. Please login the Web Client of NVR (See 14.2 Web LAN Access or 14.3 Web WAN Access for details). Click Settings Network Port to go to the
following page.
2. Check "Enable virtual host" and then click "Apply".
3. Click Camera Edit Camera to go to the following interface.
4. Select the camera and click to log in the web client of the camera. Then you can set the parameters of the camera as needed.
Note: If the IPC is not directly connected to the PoE port of the NVR, the page will not be jumped by clicking .

13.1.3 PPPoE Configuration

Click Start Settings Network PPPoE to go to the interface as shown below. Check "Enable" in "PPPoE Settings" and then enter the username
and password obtained from the dealer. Click "Apply" to save the settings.
77