Nat Configuration; Platform Access - Speco HRLN User Manual

Device Management
11.1.7 802.1X
If it is enabled, the DVR data can be protected. When the DVR is connected to the network protected by the IEEE 802.1X, user authentication is
needed.
To use this function, the DVR shall be connected to a switch supporting 802.1x protocol. The switch can be considered as an authentication system
to identify the device in a local network. If the DVR connected to the network interface of the switch has passed the authentication of the switch, it
can be accessed via the local network.
Protocol type and EAPOL version: Please use the default settings.
Username and password: The username and password must be the same as the username and password applied for and registered in the
authentication server.

11.1.8 NAT Configuration

Click StartSettingsNetworkNAT to go to the interface for NAT configuration and check "Enable". Click "Apply" to save the settings and make
note of the QR code number under the QR code. Via Internet Explorer, go to connect.specotech.cloud, input the QR code number, your username
and password to login.
You can also scan the QR Code through the Speco Blue app on your mobile client phone or tablet to log into the recorder instantly.

11.1.9 Platform Access

This function is mainly used for connecting SpecoVMS. The set-up steps are as follows.
Click StartSettingsNetworkPlatform Access to go to the interface.
76
DVR User Manual