Speco N8NRN User Manual page 15

EZ Setup & Main Interface
⑥ Add Camera. Add cameras via PoE first before adding any cameras from the LAN. Speco cameras added via the PoE ports will automatically be
added to the corresponding channel. To add cameras from the LAN, make sure all cameras are set to DHCP. Click "Refresh" to refresh the list of
online IP cameras which are in the same local network with NVR and then click
cameras in the list. Click
Click to edit the searched IP camera as shown on the below left. Enter the new IP address, subnet mask, gateway, username and the
password of the camera. You can check "Sync to IPC" to modify the IP address of the IPC via different network segments for being in the same
network segment with the NVR. Click "OK" to save the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name, IP address, port, username and the password of
the camera. You can click "Test" to test the effectiveness of the input information. Click "OK" to save the settings. You can change the IP camera
name only when the added camera is online. Click "Next" to continue.
⑦ Record Settings. Two record modes are available: auto and manual.
Auto: Select one auto mode in the interface as shown below and then click "Next" button to save the settings. Click "Advanced" to self-define
record mode. See 7.1.1 Mode Configuration for details.
to delete the added camera. Click "Delete All" to delete all the added cameras.
to add the searched camera. Click "Add All" to add all the
9
NVR User Manual