Nat Configuration; View Network Status; Basic Configuration; General Configuration - Speco NRL User Manual

Table of Contents

Device Management

11.1.7 NAT Configuration

Click StartSettingsNetworkNAT to go to the interface for NAT configuration and check "Enable". Click "Apply" to save the settings and make

note of the QR code number under the QR code. Via Internet Explorer, go to connect.specotech.cloud, input the QR code number, your username

and password to login.

You can also scan the QRCode through mobile client which is installed in the mobile phone or PAD to log in the mobile client instantly.

Click StartSettingsNetworkNetwork Status to view the network status or click

to view network status conveniently.

Click StartSettingsSystemBasicGeneral Settings to go to the following interface. Set the device name, device No., language, video format

and main output. Enable or disable wizard, "Log In Automatically", "Log Out Automatically" (if checked, you can set the wait time), "App Live Self-

Adaption" and "Dwell Automatically" (if checked, you can set the wait time). Click "Apply" to save the settings.

Device Name: The name of the device. It may display on the client end or CMS that help user to recognize the device remotely.

Video Format: Two modes: PAL and NTSC. Select the video format according to the camera.

Sequence Automatically: Check it and set "wait time".The system will sequence automatically if it is not operated during the time you set.

Click StartSettingsSystemBasicDate and Time to go to the interface as shown below.

Set the system time, date format, time format and time zone of the NVR. The default time zone is GMT+08 Beijing, Hong Kong, Shanghai, Taipei. If

the selected time zone includes DST, the DST of the time zone will be checked by default. Click "Apply" to save the settings.

on the tool bar at the bottom of the live view interface

NVR User Manual

Table of Contents

N4nrl N8nrl N8nrl2tb