Intrusion Detection - Speco N8NRN User Manual

AI Event Management
some IPCs can detect human or vehicle separately. If the camera doesn't support this function, please skip this step.
⑥ Click"..."to choose "Save original picture" or "Save target picture" on the SD card of the camera. (If your camera doesn't support this function,
please skip this step).
⑦ Click "Trigger Mode" to configure tripwire alarm linkage items.
Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm linkage settings are the
same as the face detection alarm (see 9.1.1 Face Detection for details).
Enable "IPC_Audio" or "IPC_Light" as needed (only some IPCs support these two functions). To set the IPC voice and its times and volume,
please refer to 11.6.6 Digital Deterrent for details. To set the light flashing time and frequency of the IPC, please refer to 11.6.7 Light for details.
⑧ Click "Apply" to save the settings.

9.4 Intrusion Detection

Intrusion Detection Configuration:
Alarms will be triggered if the people or vehicles intrude into the pre-defined area.
① Click Start Settings AI/Event
② Select the camera, enable the intrusion detection by IPC and set the duration.
Note: Some models may support tripwire detection by NVR.
③ Select regional activities. "Appear" or "Cross" can be selected (if your camera doesn't support region entrance/exiting detection, "Cross" will
not be enabled). If "Cross" is selected, you can choose the crossing direction.
④ Select the alarm area. Up to 4 alarm areas can be set up.
⑤ Draw the alarm area of the intrusion detection. Refer to the interface as shown below. Check "Draw Area" and then click around the area
where you want to set as the alarm area in the image (the alarm area should be a closed area). Uncheck the "Draw Area" if you finish the drawing.
Click the "Clear" to delete the alarm area.
⑥ Click "Detection Target" to choose the detection target and the sensitivity. The detection target includes people, vehicle and non-vehicle.
⑦ Click "Trigger Mode" to configure intrusion detection alarm linkage items.
Enable or disable "Record", "Snapshot", "Push", "Alarm-out", "Preset", "Buzzer", "Pop-up Video" and "E-mail". The alarm linkage settings are the
same as the face detection alarm (see 9.1.1 Face Detection Settings for details).
Enable "IPC_Audio" or "IPC_Light" as needed. (only some IPCs support these two functions). To set the IPC voice and its times and volume,
please refer to 11.6.6 Digital Deterrent for details. To set the light flashing time and frequency of the IPC, please refer to 11.6.7 Light for details.
⑧ Click "Copy To" to copy all settings to other cameras.
⑨ Click "Apply" to save the settings.
AI Event Intrusion to go to the following interface.
52
NVR User Manual