License Plate Recognition Settings; Tripwire - Speco N8NRN User Manual

AI Event Management
② Enter the plate, vehicle owner and mobile phone number.
③ Select the vehicle type and group.
④ Enable validity period to set the start and end time
⑤ Finally click "OK" to complete.
Select the added plate and then click
by clicking "Import and Export". You can click "Plate Information Description" to view the detailed information about how to import or export the
plate list.

9.2.3 License Plate Recognition Settings

① In the LPR interface, click the "Recognition" tab. Then enable "Successful Recognition" or "Strange Plate".
② Set the successful recognition alarm linkage.
Select one or more plate groups and then choose the schedule. Click "Manage" to set the schedule.
Set the text prompt. When the captured plate is matched successfully, the text will appear on the right of the live view interface.
Enable alarm output pulse (access control).
Trigger record, snapshot, alarm-out, buzzer, push, pop-up video, E-mail and pop-up message box as needed. The alarm linkage settings are
similar to the face detection alarm (See 9.1.1 Face Detection Settings for details).
③ Set the strange plate alarm linkage. When the captured plate picture doesn't match the plates in the plate database or their similarity is lower
than the set value, the captured plate will be regarded as a strange plate.

9.3 Tripwire

Tripwire/Line Crossing Configuration:
Alarms will be triggered if people or vehicles cross the pre-defined alarm line.
① Click Start Settings AI/Event AI Event
② Select the camera, enable tripwire detection by IPC and set the duration.
Note: Some models may support tripwire detection by NVR.
③ Select the direction.
Direction: A<->B, A->B and A<-B optional. It is the crossing direction of the target that crosses over the alert line.
A<->B: the alarm triggers when the target crosses over the alert line from B to A or from A to B.
A->B: the alarm triggers when the target crosses over the alert line from A to B.
A<-B: the alarm triggers when the target crosses over the alert line from B to A.
④ Draw line. Refer to the interface as shown above. Check "Draw line" and then drag the mouse in the image to draw an alert line. Uncheck the
"Draw line" if you finish the drawing. Click the "Clear" to delete the alert line.
⑤ Click "Detection Target" to choose the detection target and the sensitivity. The detection target includes people, vehicle and non-vehicle. Only
to modify its information; click
Tripwire to go to the following interface.
to delete this plate. The plates can be imported and exported in bulk
51
NVR User Manual