F430-F Series System Configuration - Omron MicroHAWK F440-F Series User Manual

*1 If monitor display is not required, it is not necessary to connect with a PC during operation.
Connecting by Serial (RS-232)
Triggers and Serial command input, as well as Read result judgement and Read string content data
output is transmitted over RS-232C cable. Triggers can also be input over parallel.
Basic configuration
Smart Camera (F440-F)
*1
*1 If monitor display is not required, it is not necessary to connect with a PC during operation.
Additional Information
The cable to use for Serial (RS-232C) communication is RS-232C-I/O Y cable (V430-
WQR-3M). Please use this cable when connecting to a PC by RS-232C.
When connecting with OMRON CS/CJ/NJ series controller, connect OMRON Programmable
Controller (CS/CJ/NJ) RS-232C cable (V430-WPLC-2M) between RS-232C-I/O Y cable (V430-
WQR-3M) and I/O control PLC (*2 in the figure).
For wiring different from that of IBM compatible PC, either make your own convertor cable, or
use the discrete wire cable type (V430-W8□ Series) with its RxD signal and TxD signal convert-
ed.
1-1-2

F430-F Series System Configuration

The F430-F can be used in the following types of system configurations.
Connection using Parallel Interface
Trigger inputs and OK/NG Judgement result outputs are received and sent over I/O cable.
Basic configuration
Smart Camera (F430-F)
*1
*1 If monitor display is not required, it is not necessary to connect with a PC during operation.
F440-F/F430-F/F420-F Series Smart Camera User's Manual for Communication Settings (Z444)
RS-232C- I/O
2-way cable
V430-WQR-3M
Special I/O cable
V430-W8-3M
Ethernet cable
98-000133-01
Computer
AutoVISION
Special-purpose
I/O cable
V430-W8-3M
Special-purpose
Ethernet cable
V430-WE-3M
Computer
AutoVISION
1 Communication Specifications Overview
External devices
Trigger sensor
I/O control PLC
*2
External devices
Trigger sensor
I/O control PLC
1
1-3