Omron MicroHAWK F440-F Series User Manual page 120

Appendices
 Command Format
JOBDOWNLOAD -transfer=SettingValue -size=SettingValue -c<CR>
• Insert a space between the command and the parameters.
• Insert a space between each parameter.
• Add a delimiter <CR> to the end of the command or parameter.
• No space is required between the parameter and the delimiter.
• Refer to the table below for the setting values.
Required Parameter
Parameter
-transfer
Option Parameter
Parameter
-size
-c
 Response Format
• When -transfer=ftp
If processed normally:
• Without the -c option, the response will be as follows.
FTP job load initialized. Please ftp avz file to /streamd0 and issue jobload -mem<CR><LF>!
OK<CR><LF><ETX>
• If the command is canceled with the -c option, the response will be as follows.
FTP load cancelled.<CR><LF>!OK<CR><LF><ETX>
If not processed normally:
• If the command fails to create a drive via FTP
Failed to create ram drive for FTP load. Requested size: [size] MemContig: [mem]<CR><LF>!
ERROR<CR><LF><ETX>
• If data is already loaded via FTP
FTP load already in progress.<CR><LF>!ERROR<CR><LF><ETX>
• If the AVZ file size is too large to load the data
A-16
Setting value
•
Specifies the transfer method.
ftp
•
ymodem Ymodem supported only over RS-232; FTP supported only over
network connectionymodem.
Setting value
- When a job is downloaded to the camera via FTP, this com-
mand creates a RAM disk to hold the .avz file until the JOB-
LOAD –mem –r command is executed. This RAM disk must be
larger than the .avz that is to be transferred.
If manually setting the size use this equation to determine the
maximum size that can be used:
(available contiguous RAM – 15 MB) / 2
The available contiguous RAM, is the second value reported by
the serial command MEMINFO.
The default RAM disk size is 10 MB.
None Cancels a previous JOBDOWNLOAD request that is either
complete or in progress.
If the previous JOBDOWNLOAD is a transfer executed via FTP,
delete /streamd0 on the RAM disk.
F440-F/F430-F/F420-F Series Smart Camera User's Manual for Communication Settings (Z444)
Description
Description