Communications Settings; Communication Specifications Settings (Profinet) - Omron MicroHAWK F440-F Series User Manual

3 Controlling Operation and Data Output with Ethernet
3-3-3

Communications Settings

The following settings are required to use PROFINET communications.
Configure Network Settings of F440/F430
Configure Default PROFINET Settings
Configure IO Supervisor (Computer) Settings
•
IP Address Settings
Configure IO Controller Settings
•
IP Address Settings
•
PROFINET IO System Settings
•
IO Device Settings and Assignments
•
Compile and Save Settings
Transfer Settings and Check Connection
•
Check IO Controller Connection
•
Transfer Parameters
•
Check Connection Status
•
Check Data Assignments
3-3-4

Communication Specifications Settings (PROFINET)

Configuring Network Settings of F440/F430
1
Launch the AutoVISION software.
The OMRON AutoVISION startup screen is displayed.
3-44
⇩
⇩
⇩
⇩
F440-F/F430-F/F420-F Series Smart Camera User's Manual for Communication Settings (Z444)
Set the IP address and industrial protocol.
For details, refer to Configuring Network Settings of
F440/F430 on page 3-44.
Configure the settings with the engineering tool as
SysmacStudio. If you are setting the F440/F430 as
an IO device, install a GSD file that defines the F440/
F430 IO data CR connection information in the engi-
neering tool.
For PROFINET IO system settings, refer to applica-
ble engineering tool manual(s).
Connect the computer (engineering tool), F440/
F430, and external devices, and use the engineering
tool to transfer settings and check communication.