Your Receiver; Pin Code Default: 0000; Front And Side Panel; Rear Panel - Strong SRT 7008 User Manual

It is advised not to store important information on USB storage devices used with
n
the receiver. Always make backups of data on your USB storage device before using
it with this receiver. STRONG will not take responsibility for any loss of information or
circumstances caused by loss of information.
STRONG cannot guarantee the playback of all files although extensions are listed, as it
n
depends on file size, codec, bit rate and resolution.
Please ensure that either the USB device is already formatted to FAT/FAT32, or format
n
the USB device via your receiver, refer to chapter 7.7 USB for details.
*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via USB has
not yet been installed.

2.0 YOUR RECEIVER

2.1 PIN code default: 0000

2.2 Front and side panel

1. Standby indicator: Shows power state of the receiver
2. Remote control sensor:
3. USB

2.3 Rear panel

1. SAT IN
2. Ethernet
3. HDMI
4. S/PDIF coaxial
5. Audio L/R
6. Power connector The receiver requires a wall adapter, mains voltage input

2.4 Remote Control

1. q
2. !
3. 0-9
4. TV/R
5. 
Green LED - receiver is turned on
Red LED - receiver is in standby mode
Receives the signal from the remote control
For connection of USB device for Multimedia use
To connect to the LNB of your satellite dish for reception of
satellite broadcast signal
To connect to a network switch, router or modem
To connect to the HDMI input of your TV using a good quality
HDMI cable
To connect to a digital or home cinema audio amplifier
To connect to an analogue amplifier for stereo audio
100~240 V AC 50~60 Hz 12 V, 1.5 A DC output. Please check the
local power conditions before connecting the receiver to the
mains supply
Turns the receiver ON/Standby
To turn the sound on or off
Channel number and numeric value input
Toggles between TV and radio mode
No function
Fig. 1
Fig. 2
Fig. 3
5