Usb - Strong SRT 7008 User Manual

WARNING
Information
Software update
Select Software Update in the main menu and press OK or u to select.
Download the required update file for your receiver model from the support page on our website
www.strong.tv or contact your local dealer. Unzip the file on your computer, if necessary, and copy
it to root folder of your USB storage device. Connect the USB storage device to the USB port of the
receiver. Press MENU and select Software Update By USB. Press OK to enter the software file list. Select
the file containing the software image and press OK to initiate the software update. An attention
banner will now be displayed. Press OK to start the update (or  to cancel it). Follow the instructions
displayed on screen. The update process will take some time. After the update process has been
completed the receiver will restart and show the last watched channel.
WARNING
Banner on screen:

7.7 USB

Press MENU and select USB. The menu provides the Multimedia feature for playback of Music, Photo
and Movie. The different file formats listed below are supported. In this menu you can make movie
and photo configurations and format the USB device into a format accepted by the receiver. The unit
supports USB devices with FAT and FAT32 format. Make sure your USB device is formatted correctly.
NOTE:
STRONG cannot guarantee compatibility (operation and/or bus power) with all USB
n
mass storage devices and assumes no responsibility for any loss of data that may occur
when connected to this unit.
With large amounts of data, it may take longer for the system to read the contents of
n
a USB device.
Some USB devices may not be properly recognized. Even when they are in a
n
supported format, some files may not play or display depending on the content.
A factory reset will permanently delete all your personal settings, timers
and stored channels. Please consider this before you perform a factory
reset.
Read the technical details of your receiver, like model number, Software/
Hardware version and serial number. This information could be asked during
a service call or repair request.
NEVER power off the receiver or remove the USB device during the
software update process. Doing so might cause irreparable damage to
your receiver and will void your warranty.
Set the time-out for the info banner. Possible settings are: 3, 5, 7 seconds.
21