Strong SRT 7008 User Manual page 22

Edit satellites:
Delete satellite:
7.3.1.6 Transponder Edit options
Note:
Add transponder:
Edit transponder:
Delete transponder:
7.3.2 DB Management
This menu allows you to save and reload the channel Data Base of your receiver from/to a USB-
device. This very convenient feature enables you to save your personal settings like Channel-,
Favourite-, Sat- and TP-lists on an USB storage device and load them back to the receiver later. This
feature is especially helpful after unintentional changes or factory reset. In such cases just skip the
First Installation by pressing  in Installation guide and select the DB management menu. Connect the
USB storage device to you receiver and select one of the options:
7.3.2.1 Load from USB
Press OK for displaying the list with available DB files (if any stored before).
The DB files „HB_DATABASE_DDMM.DBM" are shown with their built date (day and month). Select
the DB file you want to load and confirm it with OK. When the DB has been successfully loaded
(message appears on screen) the receiver will switch automatically to the first stored channel and
show its content in the background. Press  until the OSD menu disappears.
7.3.2.2 Backup to USB
Press OK to make a backup of the data base. A DBM file „HB_DATABASE_DDMM.DBM" with the
current date (day and month), will be created on the USB device. When the DB has been successfully
stored a message will be displayed on screen. Press  until the OSD menu disappears.
7.3.2.3 SatCR
If a SatCR LNB is used, please refer to the manual of that LNB to obtain the technical data about User
Bands numbers and corresponding frequencies.
18
Press GREEN to edit the focused satellite. For changing settings see
explanation above. Confirm changes with OK or cancel by .
Press YELLOW to delete the focused satellite. Press OK to confirm deleting or
 to cancel.
Transponders can only be edited when the transponder list is on screen. To
do this, select the satellite you want to edit and press 4 to open the TP list.
The options below are now available.
Press RED to add a new transponder. In the pop-up banner, enter the
transponder´s data by using the p/q tu and 0 ~ 9 buttons. Confirm the
settings with OK or cancel with . An existing TP cannot be stored again
under the same satellite.
Press GREEN to edit the highlighted transponder. In the pop-up banner,
change the transponder´s data by using the navigation and numeric buttons.
Confirm changes with OK or cancel with .
Press YELLOW to delete the highlighted transponder. Press OK to confirm or
 to cancel.