Table of Contents
Advertisement
DiSEqC 1.3
DiSEqC 1.3 (also known as GotoX) is an automated system for finding satellites with a motor driven
dish. It is an enhancement of the DiSEqC 1.2 protocol, where it was still needed to manually search
and store every satellite individually. With DiSEqC 1.3 every satellite position is automatically
calculated for a defined geographical location on earth. Only this location is needed to be entered
and stored in to the box, in conjunction with a DiSEqC 1.3 capable motor drive, all (pre-installed)
satellites can easily be found. The dish/motor-combination itself needs to be aligned due South
(North for Southern hemisphere) at its reference position at 0°. Refer to the manual of your motor-
drive for more detailed information.
Select DiSEqC 1.3 with the tu buttons. Press the GREEN button to setup your location coordinates. A
pop-up window will appear, in which the following settings can be made:
Location:
When all settings have been made, press to save the data and leave the window.
Note:
Press OK to enter the GotoX menu.
Select Goto Reference to move the dish to the reference position of 0°. Press OK twice to move.
If your dish is physically obstructed to the East or West (example by a wall), you can limit its moving
range by pressing the RED button to Set Limit to prevent it hitting the obstruction.
Use:
Move Continue:
Move Step(1):
7.3.1.3 Channel Scan
Automatic Scan
Satellite Scan:
Scan Mode:
Default:
16
to the opposite direction. Moving outside the range of your dish will thus be
prevented. Both limits can be disabled with Disable Limit.
Longitude Direction: Choose East or West.
Longitude Angle: Use the 0 ~ 9 buttons to enter the coordinate.
Latitude Direction: Choose North or South.
Latitude Angle: Use the 0 ~ 9 buttons to enter the coordinate.
The location setting only needs to be entered once, and is valid for all
satellites. If needed, the motor can physically be brought to its 0° reference
position, to align the dish South (or North for for Southern hemisphere)
first.
Press tu for moving West/East. Press the opposite tu to stop moving.
Press tu for moving West/East in 0.3° step. Check if you are still well clear of
the obstruction. Then select Set East or West Limit, according to the direction,
and press OK twice to store. Repeat if there is also an obstruction to the
opposite direction. When accidentally selecting satellites from the list which
are out of range by your dish, it will not run in to the obstruction. Both limits
can be disabled with Disable Limit.
Select a satellite in the left window to be scanned. More than one can be
selected. Press BLUE for Scan. A window with scan settings will be displayed.
Use tu to select Default, Blind Scan or NetWork.
All stored transponders in the memory will be scanned.
Advertisement
Table of Contents
