Strong SRT 7008 User Manual page 21

Blind Scan:
NetWork:
Scan type:
Service Type:
After configuring, press OK or BLUE again to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown on
screen. During the channel search you can skip transponders by pressing the MENU button, or quit
the scan process with . When the process has been completed, all found channels will be stored
and the receiver will switch to the first found channel.
Multi-Satellites Scan:
7.3.1.4 Scanning by transponder (Manual Scan)
Press 4 for displaying the transponder list of the highlighted satellite. By pressing Press 4 again you
can switch back to the satellites list.
Single Transponder Scan:
Multi-Transponder Scan:
7.3.1.5 Satellite Edit options
Add satellites:
Satellite Name:
Slow scan in 2 MHz steps. The receiver will first scan the whole frequency
band to find the transponders it can lock on. After gathering all transponders,
it scans the transponders one by one to get all available programmes.
Network search will be performed – when network information is broadcast,
new transponders will be found and stored.
Press tu to select All Channels (scrambled and free) or FTA Channels (free to
air);
Press tu to select ALL, DTV or Radio.
When using a multi feed antenna with more than 1 LNB, select the satellites
your antenna is adjusted to with the OK button. The selected satellites will be
marked by the z symbol. Set the appropriate LNB inputs in the DiSEqC point
and press BLUE for Scan. A window with scanning settings will be displayed.
After configuring the settings like explained in Single Satellite Scan above,
press OK or BLUE again to start Multi-Scan on all selected satellites.
Use the p/q buttons to highlight the transponder you want to scan and
press OK. Press BLUE for Scan. A window with scanning settings will be
displayed. After configuring the settings (explained in 7.3.1.3 above), press
OK or BLUE again to start the scanning of the highlighted transponder. When
the scan process has been completed, all found channels will be stored and
the receiver will switch to the first found channel.
Select the transponders you want to scan with the OK button. The selected
transponders will be marked with the z symbol. Press BLUE for Scan. A
window with scan settings will be displayed. After configuring the settings
like explained in 7.3.1.2 above, press OK or BLUE again to start Multi-Scan on
all selected transponders.
Press RED to add a new satellite. In the pop-up banner, enter the satellite's
name and position by using the p/q tu and 0 ~ 9 buttons.
Press OK to enter text input mode. In the key table select a character by using
the navigation buttons. Press OK to enter the chosen character. When you
have entered the name, navigate to the "OK" button on screen and press OK
on the remote control to confirm the new name. Save the settings with OK or
cancel by .
17