Troubleshooting - Strong SRT 7008 User Manual

Digital hd satellite receiver
Table of Contents

Advertisement

BLUE
*This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via USB has
not yet been installed.
7.7.4.5 DVR Configure*
Find technical details about your USB device, like Partitions, Timeshiftsize, Total space and Free space.
7.7.4.6 Format*
WARNING
If you have multiple partitions on your storage device, select the partition you would like to format
and press OK to continue. An attention banner will now be displayed. Press OK to start formatting (or
 to cancel it). The format procedure will take some time, depending on the size of the used storage
device. At the end of the process, the "Formatting is complete" message will appear. Press  to exit
the menu.

8.0 TROUBLESHOOTING

There may be various reasons for abnormal operation of the receiver. Please check the receiver
according to the procedures shown below. If the receiver does not work properly after checking it,
please contact your local Service line or STRONG dealer. Alternatively, you can send a support mail via
our website: www.strong.tv. NEVER open or disassemble your receiver. This may cause a dangerous
situation and will void the warranty.
PROBLEM
The standby indicator does
not light up
No picture
Allows you to enter the time to start playback. To enter the desired time use
0-9 and press OK to start the playback at this time.
The format function will delete all data and information from your USB
device or selected partition. STRONG will not take any responsibility for
damaged or lost data on the USB device.
POSSIBLE CAUSE
The mains lead is unplugged/
the multipoint connector is
switched off.
The receiver can't receive
signal.
Incorrect values of some tuner
parameters.
Wrong direction of the dish.
WHAT TO DO
Check the mains lead/switch
the multipoint connector on.
Check the antenna cable,
replace the cable, or connect
the cable to the receiver
tightly.
Set the values of tuner
parameters correctly in the
Installation menu.
Check signal strength and
adjust your dish correctly.
25

Advertisement

Table of Contents
loading

Table of Contents