Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 76

1. Insert the first valid key into the ignition
switch and turn the key to the "ON" posi-
tion for 5 seconds.
2. Turn the key to the "OFF" position and
remove the first key.
3. Within 30 seconds of removing the first
key, insert the second valid key into the
ignition and turn it to the "ON" position.
About 10 seconds later, the immobilizer
indicator will start to blink.
4. When the immobilizer indicator starts
blinking, turn the second valid key to the
"OFF" position and remove it. Within 30
seconds after doing so, insert a blank
immobilizer key into the ignition switch
and turn it to the "ON" position. Perform
this operation no more than 30 seconds
after the immobilizer indicator starts
blinking. When registration of the ID
code is complete, the immobilizer indica-
tor will come on for 3 seconds then go off.
If an error occurs, the immobilizer indica-
tor will go off during the procedure.
NOTE
 When the key registration is completed, the
immobilizer indicator will come on within 3
seconds of turning the ignition switch to the
"ON" position with the blank immobilizer
key (specially cut for your vehicle at your
Mitsubishi Motors dealer).
5. If you wish to register another key, per-
form the process again from step 1.
NOTE
 It is not possible to register a key if:
• the immobilizer indicator goes off during
the procedure
• the immobilizer indicator does not come on
within 30 seconds after step 4.
 The procedure will be terminated automati-
cally if:
• a period of 30 seconds or longer elapses
from the moment when the first key is
turned to the "OFF" position to the moment
when the second key is turned to the "ON"
position
• a period of 30 seconds or longer elapses
from the moment when the second key is
turned to the "OFF" position to the moment
when the blank immobilizer key is turned
to the "ON" position
• more than 20 seconds elapses after the
immobilizer indicator starts blinking
Electronic immobilizer (Anti-theft starting system)
General information
Your electronic immobilizer operates on a
radio frequency subject to Federal Communi-
cations Commission (FCC) Rules. This
device complies with part 15 of FCC Rules.
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation of this device.
WARNING
 Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to operate the equipment.
Features and controls
N00562301137
5
5-5