Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 53

Child restraint systems
CAUTION
 After removing the child restraint system, be
sure to perform the following actions.
• Wind up the seat belt completely to deacti-
vate the ALR mode.
4
• Install the head restraint.
Booster seat
A- High back booster seat
B- Booster cushion
WARNING
 To avoid injury to child, do not use the
lap/shoulder belt Automatic
Retractor (ALR) child restraint installa-
tion function when using a booster seat
with the seat belts.
4-24 Seat and restraint systems
 High back booster seat
1. Place the high back booster seat on the
seat where you wish to install it.
To help assure proper fitting of the high
back booster seat, always remove the head
restraint.
If your high back booster seat requires the
use of a tether strap, fasten the tether strap
in accordance with the following proce-
dures.
2. Open the cover from the tether anchor
installation point by pulling it back with
your hand as illustrated below (2).
3. Latch the tether strap hook (A) of the
child restraint system to the tether anchor
bar (B) as illustrated below (3) and tighten
the top tether strap so it is securely fas-
tened.
Locking
WARNING
 Child restraint system tether anchors are
designed only to withstand loads from cor-
rectly fitted child restraint systems.
Under no circumstances are they to be
used for adult seat belts, harnesses, for
attaching other items, or equipment to the
vehicle.
4. Sit the child in the high back booster seat.
Fit the seat belt to the high back booster
seat according to the child restraint sys-
tem's manufacturer.
CAUTION
 After removing the high back booster seat,
install the head restraint.
 Booster cushion
CAUTION
 Do not remove the head restraint when
installing a booster cushion.
1. Place the booster cushion on the seat
where you wish to install it.
2. Sit the child in the booster cushion. Fit the
seat belt to the booster cushion according
to the child restraint system's manufac-
turer.