Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 115

Continuously variable transmission (CVT) (if so equipped)
5
Set the selector lever in the gate to
operate while the brake pedal is
depressed.
Set the selector lever in the gate to
operate.
WARNING
 Always press the brake pedal when shift-
ing the selector lever into a selector posi-
tion from the "N" (NEUTRAL) position.
When beginning to drive, do not shift the
selector lever from the "N" (NEUTRAL)
position while pressing the accelerator
pedal. This will cause the vehicle to
"jump" forward or backward.
5-44 Features and controls
NOTE
 To prevent mistakes in operating the lever,
make sure you stop briefly at each position.
After operating, check the position in the
multi-information display.
 If the brake pedal is not depressed and held,
the shift-lock device activates to prevent the
selector lever from being moved from the
"P" (PARK) position.
 For a shift indicated by
tion, depress the brake pedal before moving
the selector lever. If you attempt to move the
selector lever before depressing the brake
pedal, the selector lever may not move.
When the selector lever cannot be
shifted from the "P" (PARK) posi-
tion
When the selector lever cannot be shifted
from the "P" (PARK) position to another
position while the brake pedal is pressed and
held down with the ignition switch or the
operation mode in ON, the battery may be flat
or the shift-lock mechanism may be malfunc-
tioning.
Immediately have your vehicle checked by an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
If you need to move the vehicle, shift the
selector lever as follows.
1. Make sure the parking brake is fully
applied.
2. Stop the engine if it is running.
3. Insert a screwdriver with a cloth over its
tip into the notch (A) of the cover. Pry
gently as shown to remove the cover.
in the illustra-
4. Depress the brake pedal with the right
N00563300049
foot.
5. Insert a screwdriver in the shift-lock
release hole (B). Shift the selector lever to
the "N" (NEUTRAL) position while
pressing the screwdriver down.