Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 47

Child restraint systems
Examples of child restraint sys-
tems compatible with the LATCH
system
4
A- Rear-facing child restraint system
B- Front-facing child restraint system
C- Child restraint system lower anchor
connectors
D- Tether strap
(These are only examples.)
Using the LATCH system
Except for booster seat
1. In order to securely fasten the tether strap,
remove the head restraint from the loca-
tion where you wish to install the child
restraint system.
4-18 Seat and restraint systems
2. Open the gap a little between the seat
cushion (A) and the seatback (B) with
your hand to locate the lower anchors (C).
3. Push the anchor connectors (D) on the
child restraint system into the lower
N00419000202
anchors (C) in accordance with the
instructions provided by the child restraint
system manufacturer.
Remember, the lower anchors provided
with your vehicle are designed to secure
suitable child restraint systems compat-
ible with the LATCH system in the out-
board positions of the rear seat only.
The anchor connectors are NOT
designed to secure a suitable child
restraint system in the center position
of the rear seat.
N00419101369
A- Vehicle seat cushion
B- Vehicle seatback
C- Lower anchor
D- Connector
NOTE
 In order to secure a child restraint system
compatible with the LATCH system, you
must use the lower anchor points in the out-
board positions of the rear seat. To secure a
child restraint system in the center position
of the rear seat, you must use the vehicle's
center seat belt.
WARNING
 If there is any foreign material in or
around the lower anchors, remove it
before installing the child restraint sys-
tem. Also, make sure the seat belt is away
from, not looped through or otherwise
interfering with, the child restraint sys-
tem. If foreign matter is not removed
and/or the seat belt interferes with the
child restraint system, the child restraint
system will not be secured properly, could
detach and move forward in the event of
sudden braking or an accident, and could
result in injury to the child or other vehi-
cle occupants.
 When the vehicle is moving, do not adjust
the seat where the child restraint system is
installed.
4. Open the cover for the tether anchor by
pulling it back with your hand as illus-
trated below (4).