Table of Contents
Advertisement
5. Latch the tether strap hook (E) of the child
restraint system to the anchor (F) as illus-
trated below (5) and tighten the top tether
strap so it is securely fastened.
WARNING
Child restraint system tether anchors are
designed only to withstand loads from cor-
rectly fitted child restraint systems. Under
no circumstances are they to be used for
adult seat belts, harnesses, or for attach-
ing other items or equipment to the vehi-
cle.
6. Before putting your child in the restraint,
push and pull the restraint in all directions
to be sure it is firmly secure. Do this
before each use. If the child restraint sys-
tem is not firmly secure, repeat steps 3
through 5.
CAUTION
After removing the child restraint system,
install the head restraint.
Booster seat
A- High back booster seat
B- Booster cushion
WARNING
To avoid injury to child, do not use the
lap/shoulder
belt
Automatic
Retractor (ALR) child restraint installa-
tion function when using a booster seat
with the seat belts.
High back booster seat
1. In order to securely fasten the tether strap,
remove the head restraint from the loca-
tion where you wish to install the high
back booster seat.
2. Open the gap a little between the seat
cushion (A) and the seatback (B) with
your hand to locate the lower anchors (C).
3. Push the anchor connectors (D) on the
high back booster seat into the lower
anchors (C) in accordance with the
instructions provided by the child restraint
system's manufacturer.
Remember, the lower anchors (C) pro-
vided with your vehicle are designed to
secure suitable high back booster seats
compatible with the LATCH system in
the outboard positions of the rear seats
only. The anchor connectors are NOT
designed to secure a suitable high back
booster seat in the middle seating posi-
tion of the rear seat.
Locking
Seat and restraint systems
Child restraint systems
4
4-19
Advertisement
Chapters
Table of Contents
