Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 130

Table of Contents

Advertisement

To deactivate
The set speed driving can be deactivated as
follows:
 Press the CRUISE CONTROL ON/OFF
switch (A). (Cruise control will be turned
off.)
 Press the CANCEL switch (D).
 Depress the brake pedal.
The set speed driving is deactivated automati-
cally in any of the following ways.
 When you depress the clutch pedal (on
vehicles equipped with manual transaxle).
 When your speed slows to about 10 mph
(15 km/h) or more below the set speed
because of a hill, etc.
 When your speed slows to about 25 mph
(40 km/h) or less.
 When the active stability control (ASC)
starts operating.
N00518801634
Refer to "Active stability control (ASC)"
on page 5-53.
WARNING
 On vehicles equipped with continuously
variable transmission (CVT), although the
set speed driving will be deactivated when
shifting to the "N" (NEUTRAL) position,
never move the selector lever to the "N"
(NEUTRAL) position while driving.
You would have no engine braking and
could cause a serious accident.
Also, the set speed driving may be deacti-
vated automatically when the engine speed
rises and approaches the tachometer's red
zone (the red-colored part of the tachometer
dial).
CAUTION
 When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by an authorized
Mitsubishi Motors dealer or a repair facility
of your choice.
Cruise control (if so equipped)
To resume the set speed
If the set speed driving is deactivated by the
condition described in "To deactivate" on
page 5-59, you can resume the previously set
speed by pressing the RES + switch (C) while
driving at a speed of about 25 mph (40 km/h)
or higher.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:
 The
CRUISE
CONTROL
switch is pressed.
 [Except for vehicles equipped with the
F.A.S.T.-key]
Turn the ignition switch to the "OFF" or
"ACC" position.
[Vehicles equipped with the F.A.S.T.-key]
Features and controls
N00518900306
5
ON/OFF
5-59

Advertisement

Table of Contents
loading

Table of Contents