Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 172

Vehicles with rain sensor
MIST- Misting function
The wipers will operate once.
OFF- Off
AUTO- Auto-wiper control
Rain sensor
The wipers will automatically
operate depending on the degree of
wetness on the windshield.
LO- Slow
HI- Fast
Rain sensor
Can only be used when the ignition switch or
the operation mode is in ON.
If the lever is put in the "AUTO" position, the
rain sensor (A) will detect the extent of rain
(or snow, other moisture, dust, etc.) and the
wipers will operate automatically.
Keep the lever in the "OFF" position if the
windshield is dirty and the weather is dry.
Wiper operation under these conditions can
scratch the windshield and damage the wip-
ers.
Wiper and washer switch
CAUTION
 With the ignition switch or the operation
mode in ON and the lever in the "AUTO"
position, the wipers may automatically oper-
ate in the situations described below.
• When cleaning the outside surface of the
windshield, if you touch the rain sensor.
• When cleaning the outside surface of the
windshield, if you wipe with a cloth the rain
sensor.
• When using an automatic car wash.
• A physical shock is applied to the wind-
shield or the rain sensor.
If your hands get trapped, you could suffer
injuries or the wipers could malfunction. Be
sure to turn the ignition switch to the "OFF"
position or put the operation mode in OFF, or
move the lever to the "OFF" position to deac-
tivate the rain sensor.
NOTE
 To protect the rubber parts of the wipers, this
operation of the wipers does not take place
even if the lever is put in the "AUTO" posi-
tion when the vehicle is stationary and the
ambient temperature is approximately 32 °F
(0 °C) or lower.
Features and controls
5
5-101