Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 173

Wiper and washer switch
NOTE
 Do not cover the sensor by affixing a sticker
or label to the windshield. Also, do not put
any water-repellent coating on the wind-
shield. The rain sensor would not be able to
detect the extent of rain, and the wipers
might stop working normally.
5
 In the following cases, the rain sensor may
be malfunctioning. Have the vehicle checked
at an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
• When the wipers operate at a constant inter-
val despite changes in the extent of rain.
• When the wipers do not operate even
though it is raining.
 The wipers may automatically operate when
things such as insects or foreign objects are
affixed to the windshield on top of the rain
sensor or when the windshield is frozen.
Objects affixed to the windshield will stop
the wipers when the wipers cannot remove
them. To operate the wipers again, move the
lever to the "LO" or "HI" position.
Also, the wipers may operate automatically
due to strong direct sunlight or electromag-
netic wave. To stop the wipers, move the
lever to the "OFF" position.
 Contact an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when replacing the windshield glass.
5-102 Features and controls
To adjust the sensitivity of the rain sensor
With the lever in the "AUTO" position, it is
possible to adjust the sensitivity of the rain
sensor by turning the knob (B).
"+"- Higher sensitivity to rain
"-"- Lower sensitivity to rain
NOTE
 Automatic wiper operation (rain sensitive)
can be changed to intermittent operation,
either vehicle speed sensitive or not vehicle
speed sensitive.
For further information, please contact your
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
Misting function
Move the lever in the direction of the arrow
and release, to operate the wipers once.
Use this function when you are driving in
mist or drizzle.
The wipers will operate once if the lever is
B
raised to the "MIST" position and released
when the ignition switch or the operation
mode is in ON or ACC. The wipers will con-
tinue to operate while the lever is held in the
"MIST" position.