Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 217

How to change a tire
7. Install the wheel nuts with their tapered
ends facing inward, then tighten by hand
until the wheel is no longer loose.
8
CAUTION
 Never apply oil to either the wheel bolts or
the nuts or they will tighten too much.
8. Lower the vehicle slowly until the tire
touches the ground, by rotating the wheel
nut wrench counterclockwise.
8-10 For emergencies
9. Tighten the nuts in the order shown in the
illustration until each nut has been tight-
ened to the torque listed here.
65 to 80 ft-lb (88 to 108 N•m)
Steel wheel
Aluminum wheel
CAUTION
 Never use your foot or a pipe extension to
apply added force to the wheel nut wrench
when tightening the wheel nuts. If you do so,
you can over-tighten the wheel nuts and
damage the wheel, wheel nuts and hub bolts.
10. Lower the jack all the way and remove it.
11. Check the tire inflation pressure. The rec-
ommended tire pressure for your vehicle
is listed on the tire and loading informa-
tion placard attached to the driver's door
sill as shown in the illustration. Refer to
"Tire inflation pressures" on page 9-16.
CAUTION
 Driving with an improperly inflated tire can
cause an accident. If you have no choice but
to drive with an under-inflated tire, keep
your speed down and avoid sudden steering
or braking, if possible. Inflate the tire to the
correct pressure as soon as possible. Refer to
"Tire inflation pressures" on page 9-16.
 After changing the tire and driving the vehi-
cle about 620 miles (1,000 km), retighten the
wheel nuts to make sure that they have not
come loose.