Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 166

How to use the AHB
1. Rotate the light switch to "
"AUTO" position (if so equipped) when
the engine is running.
2. Press the AHB switch.
The AHB is activated and the AHB indi-
cator (green) is illuminated.
If the AHB switch is pressed again, the
AHB will be deactivated and AHB indica-
tor (green) will go off.
N00593600142
" or
NOTE
 If the headlights are on when the light switch
is in the "AUTO" position (if so equipped),
the AHB works.
 You can switch the headlight beams
(high/low) manually by operating the lever
even if the AHB is working.
Refer to "Dimmer (high/low beam change)"
on page 5-94.
If the lever is operated manually, the AHB
indicator (green) will go off and the AHB
will be deactivated.
Refer to "Manual switching" on page 5-95.
 The AHB is not deactivated when you pull
the lever slightly (operation of the headlight
flasher).
Combination headlights and dimmer switch
 Manual switching
Switching to low beam
1. Pull the turn signal lever toward you.
(Green) 2. The AHB indicator (green) will go off.
3. The AHB switch is pressed again, the
AHB will be activated.
Switching to high beam
1. Pull the turn signal lever toward you.
2. The AHB indicator (green) will go off and
the high beam indicator illuminates.
3. The AHB switch is pressed again, the
AHB will be activated.
Automatic switching conditions
The high beam headlights illuminate when all
of the following conditions are met:
 Your vehicle speed exceeds approxi-
mately 33 mph (53 km/h).
 It is dark ahead of your vehicle.
 There are no vehicles in front or oncom-
ing vehicles, or none of their exterior
lights are illuminating.
The low beam headlights illuminate when
any of the following conditions occur:
Features and controls
5
N00593700101
5-95