Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 52

3. To activate the ALR child restraint instal-
lation function, slowly pull the shoulder
part of the belt all the way out of the
retractor until it stops. Then let the belt
feed back into the retractor.
4. After the belt has retracted, tug on it.
If the belt is in the ALR function, you will
not be able to pull it out. If the webbing
can be pulled out from retractor, the ALR
function has not been activated and you
will need to repeat steps 3 and 4.
5. After confirming that the belt is locked,
grab the shoulder part of the belt near the
buckle and pull up to remove any slack
from the lap part of the belt allowing the
slack to feed into the retractor. Remember,
if the lap belt portion is not tight, the child
restraint system will not be secure. It may
help to put your weight on the child
restraint system and/or push on its seat-
back while pulling up on the belt (See
illustration).
If your child restraint system requires the use
of a tether strap, fasten the tether strap in
accordance with the following procedures.
6. Open the cover from the tether anchor
installation point by pulling it back with
your hand as illustrated below (6).
Child restraint systems
7. Latch the tether strap hook (A) of the
child restraint system to the tether anchor
(B) as illustrated below (7) and tighten the
top tether strap so it is securely fastened.
WARNING
 Child restraint system tether anchors are
designed only to withstand loads from cor-
rectly fitted child restraint systems. Under
no circumstances are they to be used for
adult seat belts, harnesses, or for attach-
ing other items or equipment to the vehi-
cle.
8. Before putting your child in the restraint,
push and pull the restraint in all directions
to be sure it is firmly secure. Do this
before each use. If the child restraint sys-
tem is not firmly secure, repeat steps 1
through 7.
Seat and restraint systems
4
4-23