Table of Contents
Advertisement
Replacement of light bulbs
Rear combination lights
1. Open the trunk lid.
2. Remove the screws (A) that hold the light
unit.
9
3. Move the light unit toward the rear of the
vehicle to unfix the notch (B) and pin (C).
9-34
Vehicle care and maintenance
4. Turn the socket counterclockwise to
remove it.
N00943701673
D- Back-up light
E- Rear turn signal light
F- Do not touch the socket because replac-
ing this light is carried out by an autho-
rized Mitsubishi Motors dealer or a
repair facility of your choice.
NOTE
The following lights use an LED-type bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when either light needs to be repaired or
replaced.
• Tail and stop light
• Stop light
• Rear side-marker light
5. Remove the bulb from the socket as fol-
lows.
• Back-up light bulb
Pull the bulb out.
• Rear turn signal light bulb
Turn the bulb counterclockwise while
pressing in.
Back-up light bulb
Rear turn signal light
bulb
6. To install the bulb, perform the removal
steps in reverse.
NOTE
When mounting the light unit, align the
notch (G) and pin (H) on the light unit with
the clip (I) and hole (J) in the body.
Advertisement
Chapters
Table of Contents
