Jack And Tools - Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual

7. If there is no obvious leak source, check
the coolant level in the engine coolant res-
ervoir. If there is none, or if it is too low,
slowly add coolant.
8. If the engine coolant reservoir needs cool-
ant, you will probably also need to add
coolant to the radiator. Do not loosen or
remove the radiator cap until the engine
has cooled down.
WARNING
 Removing the radiator cap could scald
you with escaping hot water or steam.
When checking the radiator level, cover
the cap with a cloth before trying to
remove it. Turn it slowly counterclock-
wise, without pressing down, to the first
notch. The pressure in the system will then
be let out. When the pressure is COM-
PLETELY LET OUT, press down and
keep turning the cap counterclockwise
until it comes off.
9. Start the engine, and slowly add coolant,
up to the bottom of the filler neck. Use
plain water if you have to (and replace it
with the right coolant as soon as possible).
10. Replace the radiator cap and tighten it
fully. Check the coolant temperature
warning light. You can start driving again
when the high coolant temperature warn-
ing light does not come on.
11. Have the system inspected by your autho-
rized Mitsubishi Motors dealer or a repair
facility of your choice.

Jack and tools

Storage
The tools are stored beneath the floor board
of the cargo area. The jack is stored under the
driver's seat.
1- Tools
2- Jack
Tools
N00836601464
1- Tools bag
2- Wheel nut wrench
3- Jack bar
4- Towing hook
Jack
Move the driver's seat fully forward to access
the jack from the rear seat area.
(Refer to "Front seats" on page 4-3.)
CAUTION
 Never access, remove or store the jack from
the front of the driver's seat. Doing so could
damage electrical wires under the driver's
seat.
For emergencies
Jack and tools
8
8-5