Mitsubishi MOTORS MIRAGE G4 2022 Owner's Manual page 49

Child restraint systems
4
A- Vehicle seat cushion
B- Vehicle seatback
C- Lower anchor
D- Connector
WARNING
 If there is any foreign material in or
around the lower anchors, remove it
before installing the high back booster
seat. Also, make sure the seat belt is away
from, not looped through or otherwise
interfering with, the high back booster
seat. If foreign matter is not removed
and/or the seat belt interferes with the
high back booster seat, the high back
booster seat will not be secured properly,
could detach and move forward in the
event of sudden braking or an accident,
and could result in injury to the child or
other vehicle occupants.
4-20 Seat and restraint systems
WARNING
 When the vehicle is moving, do not adjust
the seat where the high back booster seat
is installed.
4. Open the cover for the tether anchor by
pulling it back with your hand as illus-
trated below (4).
5. Latch the tether strap hook (E) of the child
restraint system to the anchor (F) as illus-
trated below (5) and tighten the top tether
strap so it is securely fastened.
WARNING
 Child restraint system tether anchors are
designed only to withstand loads from cor-
rectly fitted child restraint systems.
Under no circumstances are they to be
used for adult seat belts, harnesses, for
attaching other items, or equipment to the
vehicle.
6. Before putting your child in the restraint,
push and pull the high back booster seat in
all directions to be sure it is firmly secure.
Do this before each use. If the high back
booster seat is not firmly secure, repeat
steps 3 through 5.
7. Sit the child in the high back booster seat.
Fit the seat belt to the high back booster
seat according to the child restraint sys-
tem's manufacturer.
CAUTION
 After removing the high back booster seat,
install the head restraint.