6.20. IGNITOR & FLAME
SENSOR ASSEMBLY
Nov. 2009
The flame sensor should glow a bright red when the pilot is lit
and allows the gas control valve to open. If it does not sense a
flame, it shuts off the gas control valve.
Flame Sensor Replacement:
1. Remove control panel.
2. Pull wire from flame sensor.
3. Using a 7/16" wrench, remove the nut securing the flame
senor and pull the sensor from the unit.
4. Install new flame sensor in reverse order.
Ignitor Replacement:
TO AVOID INJURY, PROPERTY DAMAGE, OR EXPLO-
SION, BEFORE STARTING THIS PROCEDURE, DO
THE FOLLOWING:
•
MOVE THE POWER/PUMP SWITCH TO THE
"OFF" POSITION.
•
DISCONNECT THE MAIN CIRCUIT BREAKER AT
THE WALL, OR UNPLUG THE POWER CORD.
•
TURN OFF THE MAIN GAS SUPPLY TO THE FRY-
ER AND DISCONNECT AND CAP THE SUPPLY
LINE TO FRYER.
1. Follow steps 1 to 3 above.
2. Using a 7/16" wrench, loosen the pilot, gas line fitting.
3. Using a small Phillip's-Head remove the 2 screws securing
the ignitor assembly.
4. Pull wire from ignition module and remove ignitor assem-
bly from unit.
5. Install new ignitor assembly in reverse order.
6-22
Model EEG-142, 143, 144