6-10. FILTER PUMP & MOTOR
(Continued)
Nov. 2009
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
Removal:
1. Remove the bottom, rear panel and the right side panel.
2. Using a 5/8" wrench, loosen the front, flexible line fitting,
on the pump.
3. Using a 1" wrench, loosen the rear pump fitting.
4. Locate the appropriate conduit on the right side of the unti
and disconnect the conduit from the fryer.
5. Using a 1/2 in. wrench, remove the 4 bolts securing the
motor to the motor bracket and pull the pump and motor
assembly from fryer.
To replace pump on motor:
1. Using a 1/2 in. wrench, remove the 2 bolts securing the
pump to the motor and pull the pump from the motor.
2. Install a new seal kit (part no. 17476) onto shaft of motor.
3. Allign the shaft of the motor with the rotor on the inside of
the pump and push pump onto shaft of motor.
4. Secure the pump onto the motor with the 2 bolts.
6-13
Model EEG-142, 143, 144