Table of Contents
Advertisement
6.20. IGNITOR & FLAME
SENSOR ASSEMBLY
May 2012
The flame sensor should glow a bright red when the pilot is lit and
allows the gas control valve to open. If it does not sense a flame, it
shuts off the gas control valve.
Flame Sensor Replacement:
1. Remove control panel.
2. Pull wire from flame sensor.
3. Using a 7/16" wrench, remove the nut securing the flame senor
and pull the sensor from the unit.
4. Install new flame sensor in reverse order.
Ignitor Replacement:
TO AVOID INJURY, PROPERTY DAMAGE, OR
EXPLOSION, BEFORE STARTING THIS
PROCEDURE, DO THE FOLLOWING:
• MOVE THE POWER/PUMP SWITCH TO THE "OFF"
POSITION.
• DISCONNECT THE MAIN CIRCUIT BREAKER
AT THE WALL, OR UNPLUG THE POWER CORD.
• TURN OFF THE MAIN GAS SUPPLY TO THE FRYER
AND DISCONNECT AND CAP THE SUPPLY LINE TO
FRYER.
1. Follow steps 1 to 3 above.
2. Using a 7/16" wrench, loosen the pilot, gas line fitting.
3. Using a small Phillip's-Head remove the 2 screws securing the
ignitor assembly.
4. Pull wire from ignition module and remove ignitor assembly
from unit.
5. Install new ignitor assembly in reverse order.
6-22
Model EEG-153, 154
Advertisement
Table of Contents
Troubleshooting
