Digi XTend User Manual page 82

Part Number Type
A92-D4PTM 900 MHz / 2.4GHz permanent mount
* FCC regulations stipulate a 36 dBm EIRP power requirement. Users implementing antenna gain greater than 6.0 dB must
compensate for the added gain with cable loss. When operating at 1 W power output, the sum (in dB) of cable loss and
antenna gain shall not exceed 6.0 dB.
Half-wave antennas (approved when operating at 100 mW power output or lower)
Part Number Type
A09-QW Quarter-wave wire
A09-QRAMM 3 " Quarter-wave wire
A09-QSM-3 Quarter-wave straight
A09-QSM-3H Heavy duty quarter-wave straight
A09-QBMM-P6I Quarter-wave w/ 6" pigtail
A09-QHRN Miniature Helical Right Angle solder
A09-QHSN Miniature Helical Right Angle solder
A09-QHSM-2 2" Straight
A09-QHRSM-2 2" Right angle
A09-QHRSM-170 1.7" Right angle
A09-QRSM-380 3.8" Right angle
A09-QAPM-520 5.2" Articulated Screw mount
A09-QSPM-3 3" Straight screw mount
A09-QAPM-3 3" Articulated screw mount
A09-QAPM-3H 3" Articulated screw mount
Yagi antennas (approved when operating at 100 mW power output or lower)
XTend RF Module User Guide
Connector Gain
RPTNC 2.1 dBi
Connector Gain Application
Permanent 1.9 dBi Fixed / Mobile
MMCX 2.1 dBi Fixed / Mobile
RPSMA 1.9 dBi Fixed / Mobile
RPSMA 1.9 dBi Fixed / Mobile
MMCX 1.9 dBi Fixed / Mobile
Permanent -1 dBi Fixed / Mobile
Permanent -1 dBi Fixed / Mobile
RPSMA 1.9 dBi Fixed / Mobile
RPSMA 1.9 dBi Fixed / Mobile
RPSMA 1.9 dBi Fixed / Mobile
RPSMA 1.9 dBi Fixed / Mobile
Permanent 1.9 dBi Fixed / Mobile
Permanent 1.9 dBi Fixed / Mobile
Permanent 1.9 dBi Fixed / Mobile
Permanent 1.9 dBi Fixed / Mobile
Agency certifications
Application
Fixed
82