Xtib-R Dip Switch; Automatic Dip Switch Configurations - Digi XTend User Manual

XTIB-R Dip switch

XTIB-R Dip switch
The DIP switch automatically configures the device to operate in different modes during the power-on sequence.
Each time the Module Assembly (interface board with a device) powers-on, intelligence on the board programs the
attached device according to the positions of the DIP Switch.
The following figure illustrates the DIP Switch settings.

Automatic DIP switch configurations

Each time you power on the Module Assembly, the firmware sends AT commands to the on-board RF module as
dictated by the positions of the DIP switches. The following figure shows the DIP switch with the various
configurations.
The following table shows the commands that the firmware sends to the module as a result of DIP switch settings. DIP
switches 3 and 4 are only used for RS-485/422 termination and do not affect the configuration of the device. In the
tables, SW means switch.
XTend RF Module User Guide 90