Command Descriptions; Board Voltage) Command - Digi XTend User Manual

AT Binary
Command Command AT Command Name
SB 0x37 (55d)
SH 0x25 (37d)
SL 0x26 (38d)
SM 0x01 (1d)
ST 0x02 (2d)
TP 0x38 (56d)
TR 0x1B (27d)
TT 0x1A (26d)
TX 0x3F (63d)
VL --
VR 0x14 (20d)
WA --
WN --
WR 0x08 (8d)
WS --
* Firmware version in which command and parameter options were first supported.

Command descriptions

Commands in this section are listed alphabetically. Command categories are designated between the "< >" symbols
that follow each command title. By default, XTend RF Modules expect numerical values in hexadecimal since the
default value of the CF (Number Base) Parameter is '1'. Hexadecimal values are designated by the "0x" prefix and
decimal values by the "d" suffix.
%V (Board Voltage) Command
<Diagnostics> %V Command is used to read the current voltage of the module circuit board.
Sample Output:
5.02 V (when ATCF = 0)
5051F (when ATCF = 1) *
5.02 (when ATCF = 2)
* When CF = 1 (default), a hex integer is shown that is equal to (voltage * 65536d).
XTend RF Module User Guide
Stop Bits
Serial Number High
Serial Number Low
Sleep Mode
Time before Sleep
Board Temperature
Delivery Failure Count
Streaming Limit
Transmit Only
Firmware Version -
verbose
Firmware Version
Active Warning Numbers
Warning Data
Write
Sticky Warning Numbers
Parameter Range
0 - 1
0 - 0xFFFF [read-only]
0 - 0xFFFF [read-only]
0 - 8 (3 is reserved)
(ATAT+3) - 0x7FFF [x 100
msec]
0 - 0x7F [read-only]
0 - 0xFFFF [read-only]
0 - 0xFFFF [0 = disabled]
0 - 1
Returns string
0 - 0xFFFF [read-only]
Returns string
Returns string
--
Returns string
Command descriptions
Command # Bytes
Category Returned
Serial Interfacing 1
Diagnostics 2
Diagnostics 2
Sleep (Low 1
Power)
Sleep (Low 2
Power)
Diagnostics 1
Diagnostics 2
Networking & 2
Security
RF Interfacing 1
Diagnostics --
Diagnostics 2
Diagnostics --
Diagnostics --
(Special) --
Diagnostics --
Factory
Default
0
varies
varies
0
0x64
(100d)
--
0
0
0
--
--
--
--
--
--
29