Sl (Serial Number Low) Command; Sm (Sleep Mode) Command - Digi XTend User Manual

SL (Serial Number Low) Command

<Diagnostics> SL Command is used to set/read the serial number low word of the RF module.
AT Command: ATSL
Binary Command: 0x26 (38 decimal)
Parameter Range (read-only): 0 - 0xFFFF
Default Parameter Value: varies
Number of bytes returned: 2
Related Commands: SH (Serial Number High)

SM (Sleep Mode) Command

<Sleep Mode (Low Power)> The SM Command is used to set/read the RF module's Sleep Mode settings that configure
the module to run in states that require minimal power consumption.
AT Command: ATSM
Binary Command: 0x01
Parameter Range: 0 - 8 (3 is reserved)
Default Parameter Value: 0
XTend RF Module User Guide
Parameter
0
1
2
3
4
5
6
7
8
Configuration
Disabled
Pin Sleep
Serial Port Sleep
[reserved]
Cyclic 1.0 second sleep
(RF module wakes every 1.0 seconds)
Cyclic 2.0 second sleep
Cyclic 4.0 second sleep
Cyclic 8.0 second sleep
Cyclic 16.0 second sleep
Command descriptions
52