Am (Auto-Set My) Command; Ap (Api Enable) Command; At (Guard Time After) Command - Digi XTend User Manual

AT Command: AT%V
Binary Command: 0x3B (59 decimal)
Parameter Range (read-only): 0x2CCCA - 0x5BFFA (2.80 - 5.75 decimal)
Number of bytes returned: 4

AM (Auto-set MY) Command

AT Command: ATAM
Binary Command: 0x40 (64 decimal)
<Networking and Security> AM Command is used to automatically set the MY (Source Address) parameter from the
factory-set serial number of the module. The address is formed with bits 29, 28 and 13-0 of the serial number (in that
order). The resulting value is displayed as a result of this command.

AP (API Enable) command

<Serial Interfacing> The AP command is used to enable the module to operate using the frame-based API operation.
AT Command: ATAP
Parameter Range:0 - 2
Parameter
0
1
2
Default Parameter Value:0
Number of Bytes Returned:1
Legacy Modem Minimum Firmware Version Required: 2.x20

AT (Guard Time After) command

<Command Mode Options> AT Command is used to set/read the time-of-silence that follows the command sequence
character (CC Command) of the AT Command Mode Sequence (BT + CC + AT). By default, 1 second must elapse before
and after the command sequence character.
The times-of-silence surrounding the command sequence character are used to prevent inadvertent entrance into AT
Command Mode.
XTend RF Module User Guide
Configuration
API Disabled (Transparent Operation)
API enabled (w/out escaped characters)
API enabled (with escaped characters)
Command descriptions
30