Install The Ultraglide Hydraulic System; Install Fittings On The Autoboom Valve - Raven AutoBoom Installation Manual

Chapter 4

Install the UltraGlide Hydraulic System

Install Fittings on the AutoBoom Valve

Before mounting the AutoBoom valve on the machine, install the proper fittings in the valve. This prepares the
valve for installation and simplifies the hose connection process later in the procedure. Refer to the following
table to install the fittings in the appropriate ports of the AutoBoom valve.
Fitting - 9/16" JIC (M) to 9/16" SAE O-Ring (M) Straight Adapter
Fitting - 3/4" JIC (M) TO 9/16" SAE O-Ring (M) Straight Adapter
30
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material from being
introduced into the machine's hydraulic system.
Objects or materials that are able to bypass the
machine's hydraulic filtration system will reduce
performance and possibly cause damage to the
AutoBoom hydraulic valve.
The appearance of the AutoBoom hydraulic
valve may vary slightly from the images
contained in this manual. However, the fittings,
hose connections, and cable connections
remain the same.
Fitting
Spra-Coupe 7X60 (2010 & Newer) AutoBoom® Installation Manual
WARNING
CAUTION
NOTICE
Part Number
333-0012-045
333-0012-055
Port
LC, RC, LSP
LV, RV