Table of Contents
Advertisement
Eden260V User Guide
Safety Features
Interlock Switch
Safety Lock
UV Screening
Circuit Breaker
DOC-32020 Rev. F
Stratasys 3D printers are designed to comply with CE and FCC
standards. They are equipped with the following safety features:
The power supplied to the UV lamp, the tray heater and the
motion motors is turned off when the cover is opened.
Warning
Do not defeat (override) the interlock switch. Doing so could
result in serious personal injury. If the interlock switch does not
function correctly, do not use the printer, and contact your service
provider.
The cover is locked while the printer is working. The lock is
released when the printer reverts to pause or stop mode.
Warning
Do not defeat (override) the safety lock. Doing so could result
in serious personal injury. If the safety lock does not function
correctly, do not use the printer, and contact your service provider.
The transparent section of the cover blocks harmful UV radiation,
allowing the operator to view models as they are being made.
Figure 2-1
Front view of the Eden260V printer
The power to the printer is turned off in case of electrical
overcurrent.
Note: The circuit breaker is only accessible to service personnel.
2 Safety
2-2
Advertisement
Table of Contents
