Replacing A Fan Tray - H3C SR6602-X1 AC Installation Manual

Remove the optical fibers from the transceiver module.
1.
Pivot the clasp down to the horizontal position.
2.
Holding the handle of the transceiver module, gently pull the transceiver module out.
3.
See Figure
Insert the plastic plug to the removed transceiver module, and put the transceiver module into
4.
its original shipping materials.
If you do not install a new transceiver module in the interface, install a dust-proof plug in the
5.
interface. To install a transceiver module, see
Figure 58 Removing a transceiver module
Figure 59 Transceiver module golden finger

Replacing a fan tray

WARNING!
Rotating fan blades can cause serious injury or cut. Make sure all fans have stopped rotating before
you take out the entire fan tray.
CAUTION:
Do not operate the system without a fan tray for more than 2 minutes.
To replace a fan tray:
Use a Phillips screwdriver to loosen the captive screw on the fan tray.
1.
Grasp the handle of the fan tray with one hand and pull the fan tray part way out the slot.
2.
Support the fan tray bottom with the other hand, and pull the fan tray slowly along the guide rails
out of the slot.
58.
"Connecting a fiber
43
cable."