Table of Contents
Advertisement
Completing the installation
To complete the installation, complete the following tasks.
1. Reinstall the optional expansion unit, if you removed one to install other
2. Close the blade server cover, unless you installed an optional expansion unit
3. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
4. Turn on the blade server (see "Turning on the blade server" on page 14).If you
5. For certain optional devices, you might have to run the blade server Setup
Installing the blade server cover
Use these instructions for information about how to close the blade server cover.
Attention: You cannot insert the blade server into the BladeCenter unit until the
cover is installed and closed or an expansion unit is installed. Do not attempt to
override this protection.
To install the blade server cover, complete the following steps:
1. Read the safety information that begins on page "Safety" on page v and
2. Close the DIMM access door by rotating the door towards the DIMM
devices (see "Installing an optional expansion unit" on page 22 for information
on installing the expansion unit).
that has its own cover (see "Installing the blade server cover").
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
server in a BladeCenter unit" on page 47).
have just connected the power cords of the BladeCenter unit to electrical
outlets, you must wait until the power-on LED on the blade server flashes
slowly before you press the power-control button.
utility to configure the blade server (see Chapter 4, "Configuring the blade
server," on page 51). See the documentation that comes with your optional
device for additional information.
"Installation guidelines" on page 17.
connectors.
Chapter 3. Installing options
45
Advertisement
Table of Contents
