Garmin LIDAR-Lite v1 Silver Label Operating Manual page 9

LIDAR­Lite Signal & Power Interface Definitions
J1 ­ Primary interface
Board Connector:​ Molex part #5023860670 (DigiKey Part #: ​
Mating Connector:​ Molex # 5023800600 PLUG HSG 6POS (DigiKey Part #: ​
Pin
PIN 1 POWER_IN – 4.75­5.5V DC Nominal, Maximum 6V DC. Peak current draw from this
input (which occurs during acquisition period) is typically < 100 mA over a duration
from 4 to 20ms depending on received signal strength. Unless you use ​
management ​
PIN 2 POWER_EN ­ Active high, enables operation of the 3.3V micro­controller regulator.
Low puts board to sleep, draws <40 μA. (Internal 100K pull­up)
PIN 3 Mode Select – Provides trigger (high­low edge) PWM out (high)
LIDAR­Lite v1 "Silver Label" Manual​ , Updated: 08/13/15
, the unit will draw 80 mA between acquisition times.
W M3917CT­ND​
Description
)
W M2271­ND)
p ower