Intended Use - WAGO 750 XTR Series System Manual

Provisions

1.1 Intended Use

The I/O system is used to receive digital and analog signals from sensors and to control
actuators. Higher-level controllers can be communicated with through fieldbus interfaces.
The signals can be (pre-)processed with the controllers.
The products are open equipment and are designed for installation in an additional enclo-
sure. Protective measures suitable for the specific application area and application must
be implemented.
• The products are intended for installation in automation technology systems.
• The products are designed for use in dry indoor rooms.
• Operation of the products in industrial areas is permitted.
• The products used fulfill the EMC requirements for large and small commercial and
business areas as well as residential areas when they maintain the required limits for
electromagnetic interference emission (EMC).
• Operation of the product in other application areas is only permitted when correspond-
ing approvals and labeling are present.
Improper Use
Improper use of the products is not permitted. Specifically, improper use occurs in the fol-
lowing cases:
• Non-observance of the intended use
• Use without protective measures in an environment in which moisture, salt water, salt
spray mist, dust, corrosive fumes, gases, direct sunlight or ionizing radiation can occur
• Use of the products in areas with special risk that require flawless continuous operation
and in which failure or operation of the product can result in an imminent risk to life,
limb or health or cause serious damage to property or the environment (such as the
operation of nuclear power plants, weapon systems , aircraft and motor vehicles)
Warranty and Liability
The terms set forth in the General Business & Contract Conditions for Delivery and Ser-
vice of WAGO GmbH & Co. KG and the terms for software products and products with in-
tegrated software stated in the WAGO Software License Contract – both available at
ü www.wago.com
• The products are used improperly.
• The deficiency (hardware and software configurations) is due to special instructions.
• Modifications to the hardware or software have been made by the user or third parties
that are not described in this documentation and that has contributed to the fault.
Individual agreements always have priority.
Obligations of Installers/Operators
The installers and operators bear responsibility for the safety of an installation or a sys-
tem assembled with the products. The installer/operator is responsible for proper installa-
tion and safety of the system. All laws, standards, guidelines, local regulations and ac-
cepted technology standards and practices applicable at the time of installation, and the
instructions in the the products' Instructions for Use, must be complied with. In addition,
the Installation regulations specified by Approvals must be observed. In the event of non-
compliance, the products may not be operated within the scope of the approval.
6 System manual | Version: 2.0.0
– shall apply. In particular, the warranty is void if:
750 XTR Series