WAGO 750 XTR Series System Manual page 54

Assembly and Disassembly
2. Press the I/O module into the assembly until the I/O module snaps onto the DIN-rail.
3. Check that the I/O module is seated securely on the DIN-rail and in the assembly.
ð Once the I/O module has snapped into place, the electrical connections for the data
contacts and power contacts (if any) to the head station or to the preceding and, if ap-
plicable, following I/O module are established.
54 System manual | Version: 2.0.0
750 XTR Series
Figure 28: Inserting the I/O Module
Figure 29: Snapping in the I/O Module