Table of Contents
Advertisement
Installation
Expansion Interface Card Installation
By default the Expansion Interface card is already installed for this model. No need to install the Expansion
Interface card. Host Interface card (HIF), is the same exact card as the EIF only that its SW1 switch is set to
"ON=EXP." The expansion system will NOT function if SW1 is set to OFF=HOST.
If you need to replace or install an Expansion Interface card follow these steps.
1.
Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable from
Expansion chassis or from computer
2.
Unscrew the Expansion Interface
3.
Install new Expansion Interface card
4.
Plug-in the card in PCIE slot#0. This is the designated slot for the interface card. Installing the Interface
card in a non-designated slot will cause the system to not operate
Roben 3 | Chapter 2
Hardware Installation
Magma
44
Advertisement
Table of Contents
