Plug-In Power Cord - Magma ROBEN Series User Manual

Plug-in Power Cord

NOTE
If at all possible, plug all power cords from the expansion chassis and your host computer into
a shared power strip, preferably one that has surge and noise suppression circuitry built into
it.
1. Plug in power cord to Roben-3. Make sure the Power Switch on the power supply is turned OFF.
2. Turn power supply switch to ON position.
3. Two green LED on the Interface card are illuminated. No LEDs are illuminated on the backplane.
Roben 3 | Chapter 2 Hardware Installation
Magma
16