Table of Contents
Advertisement
To Disconnect Ipass Cable
1.
Pull the green tab while slowly pulling out the cable from the interface card.
2.
Failure to do so can break the connector inside the interface card; this can cause the system to malfunction.
Plug-in Power Cord
1.
Connect the power cord to the power receptacle on the back of the unit.
2.
Before connecting the power cord make sure to turn off the switch.
Powering on and powering off the unit
To Turn ON:
1.
Press the Rocker switch on the power supply to On position. The (I) symbol should be pressed down.
When the chassis power is on the unit is set to stand-by mode
2.
Press the front On/Off switch to power up or turn on the Magma expansion chassis.
3.
Once the expansion unit is turned on, you can turn on the Host computer.
To Turn Off (Always power down the Host computer first before the chassis.)
1.
Press Off or shutdown computer
2.
Press the front On/Off switch on the expansion chassis
Roben 3 | Chapter 2
Hardware Installation
Magma
54
Advertisement
Table of Contents
